Crack The Fat Loss Code Ebook

Thursday, December 17, 2009

Bodybuilding Routines for the Neck: Train Your Lateral Flexors, Extensors and Traps

By Ricardo d Argence

We in general as people will normally over look the training of this crucial area for two main reasons. In addition, they are that we do not know how to do the exercise or we do not possess the equipment for the task at hand.

Lateral Flexors. The lateral flexors, which tilt the head left or right, can be worked in the same manner as the flexors. To begin, you will lie on a bench on your side, then rest a towel on the side of your head and hold a weight plate in place with your hand.

Just simply let your head tilt downwards, and then pull it back upwards as if you are trying to touch your ear to the shoulder that is off the bench. Again you must use several sets of 10-15 reps of moderate resistance before you go and switch to your other side to work out the opposite lateral flexor group.

Extensors. Extensors are a lot like the flexor groups in that they can be worked out with a head strap or neck machine. In using the head strap the most common way is to attach the end of the chain to the strap and hook to a low pulley or you can just hang plates on the chain. Then be sure to put your hands on your quads and bend at the waist.

Now you will focus more on tilting your head backwards as though you looking up. Another path to take would be to lie down on a bench with you head over the other end. Put the towel on the back of your head and put the weight on top of it.

Now while the plate is being held in your hands, let the head drop slowly, then begin to raise it bending only you neck. Having moderate resistance for a few sets of 10-15 will be ideal for you as with the other exercises.

Traps. Trapezius or Traps muscles are a part in the extensor group, so that means that they will be worked when doing other exercises that have talked about under the heading of The extensor. Moreover, they can be workout with added barbell exercises, as most people will know.

Mostly, people tend to lump basic barbell or dumbbell shrugs and the sole motion for traps. The dead lift and the various others can work the traps really hard specifically during the lockout part of the lift. Notice the huge looking traps on power lifts that have a lot of big pull.

While the deadlift is nearly always a part of my routine, I'd like to offer a few lesser-performed lifts taken from Olympic weightlifting that will hammer the traps extremely hard. The most common lift in this category would have to be the power clean and to a lesser extent, the squat clean. Because the arms are kept very straight as long as possible during the pull, the hips, traps and upper back must provide the power to accelerate the bar before dipping under it to rack the lift.

In the same way as the clean variations, the snatch will provide a lot of stimulation for the traps. The pull is going to have a rough "shrug" while the bar continues to accelerate before it dips beneath it.

I generally do the power snatch, where you don't drop as low upon completion of the lift and the bar is locked out overhead while in what would be a 1/4 squat position. I don't see a reason to go into a complete squat snatch, which does allow the use of more weight due to the deep bottom position you attain to get under the bar. I feel that the power clean and power snatch force you to pull much harder, since you'll have less time to drop under the bar to rack it.

If you are a person who suffers from tightness due to long hours of sitting on your butt in an office doing these stretches will make your life more comfortable in many ways. The power you will grow in your traps will help you pulling movements and give you a decent and finished look to your body. - 17268

About the Author:

0 Comments:

Post a Comment

Subscribe to Post Comments [Atom]

<< Home